clubstylus

Excellent news! I really hope you can make a go of it.

I've just put some replica Porsche 356 headlamps as used on some Stylus on ebay; item No. 151272035532. If someone off here wants to bid I'll reduce the postage to £5.

Cheers

Bikenuts

PM sent

PM sent Re; Rollbar

Bikenuts

Any chance I could have a copy too?
uppertown
at
hotmail
dot
com

Cheers

Matt

Hopefully you can see the attached picture. The bolts on the Atlas axle are symmetrical side to side whereas the Koln are asymmetric. As already suggested I'd leave it in until it brakes.

No problem, just didn't want you to come a cropper. T'other Matt Matt, Doesn't the 2.8 box have a different length input shaft? T'other Matt It did before I cut the shaft down to size. Had the 2.8 box behind the Zetec before. The gear ratios were much better suited, just the 1st gear is a bit short....

Matt,
Doesn't the 2.8 box have a different length input shaft?

T'other Matt

Rob (CMA) are your dampers Topped out without you in the car? I ask because if you have no initial sag from the weight of the car some of your weight may be overcoming the pre-load before the suspension starts to compress. Dropped a bollock in my previous post; the dampers are mounted part way along...

Rob (Stylussprinter)18st is near enough 250lbs, the damper/ wheel ratio on a Stylus is near enough 1:1 all round so 250 lbs is enough to depress one of his rear springs by 1" or both by 1/2"so even allowing for the majority of the drivers weight being distributed over the rear wheels I wou...

Spotted this on the 'bay - NTDWM

http://www.ebay.co.uk/itm/SSC-Sylva-Sty ... 19cccf2cef

Fairy Snuff I didn't know about the boots splitting, I was just wary of the speed at which SBs can ware out if you’re not scrupulous about keeping them clean and the fit of the taper pin to the SB looks like a potential trouble spot.

Matt again

MattD wrote: - Its the sherpa track rod-end that I'm interested in getting rid of, plus the adjustment of course.

Matt

Matt,
Why do you want to get rid of the Sherpa joint? I can understand replacing the inner plastic bushes with SBs to allow more adjustment but not the Sherpa joint.

Another Matt

Congratulations!

And a Merry Christmas and a Happy New Year to one and all ,<

Matt

Think this might be the rally;

http://www.rogeralbertclarkrally.org/RA ... ize%20Fund

The cars came through the village after the Hamsterly stages made me feel quite nostalgic .