New inlet manifold

[Shooter63]

I know this wont interest many but I had this made up for the winter upgrades, it seems very well made and for the princely sum of £120.00 delivered

Shooter

[stylussprinter]

I think it looks very nicely made and especially at £120 . My cast ally one cost that around 16 yrs ago . What engine will it fit , it's fairly short so guessing it's on throttle bodies

[Shooter63]

I think it looks very nicely made and especially at £120 . My cast ally one cost that around 16 yrs ago . What engine will it fit , it's fairly short so guessing it's on throttle bodies

Zetec engine on throttle bodies, the manifold has gained me over an inch, it's around 35mm deep to 65mm of a STD one, and dropped the set up a bit more, I'll have to run a 35/40 amp mini alternator, but no bad thing I was even thinking of running the alternator out the front of the engine, I'll wait and see.
I must admit I'm not sure how he made it so cheap, I priced up the material and that came out over £40.00 he had to write the program on the CNC as this was the first he had done, I've got a good mind to see how much he wants to make a plenum Base.

Shooter

[hearbear]

That looks well made and very neat.