Page 2 of 2
Re: Roll Bar
Posted: Fri May 15, 2009 2:36 pm
by PeteC
pete&matt p.m. sent
Pete C
Re: Roll Bar
Posted: Wed Jun 23, 2010 5:49 pm
by MattD
Have now had this done to mine....
Not totally sure its MSA compliant, but it's much better than the previous single hoop.
I think its OK so long as I don't want to be scrutineered to race, but OK for sprint's.
Made up by Nev Powell & welded in.
Just the engine install to get back to now
Re: Roll Bar
Posted: Wed Jun 23, 2010 8:32 pm
by kevp
Matt
The roll cage looks good. If the material used is up to the blue book spec, then its good enough to race. The only thing Id question on that front is the shoulder protection.
I need to contact Nev for mine.
Re: Roll Bar
Posted: Wed Jun 23, 2010 9:37 pm
by MattD
Yep, it's in the just under 2" (1 7/8" is it ??) CDS, so ok for the forward section ( main hoop must be 2").
Could always add shoulder height wings later.
Not needed right now though.
Nev has bar stock at present, so it's a good time to
ask if you want one done !