clubstylus

I've started stripping my car for the rebuild, and have some serviceable items which won't be going back on the car.
I'll add more to this thread as I get bits off the car.

1. A pair of mildly scabby door cards - could be used as is with a bit of cleaning up, re-trimmed, or used as a template - SOLD.

2. A pair of nice aluminium handles/pulls - might want to use these with the door cards, very light! - SOLD.

3. Roof bars - good condition, just a couple of touch-ups needed near the mounts where I guess they have rubbed. - SOLD.

All items listed exclude postage which will be at cost (or you can arrange collection).
Paypal acceptable, but you cover any fees.

Dave

PM Sent re: RoofBars.

Would also be interested to see what else you have for sale as Locostbuilders wants £10 for me to see what you have for sale.

CMA wrote:Would also be interested to see what else you have for sale as Locostbuilders wants £10 for me to see what you have for sale.

Ah, sorry, forgot about that, just trying to save typing everything twice!

Fiamm electric horn - SOLD

Pair of small (motorbike?) wing mirrors - SOLD

Pair of carbon effect plastic headlamp trims for 7" headlamp units - SOLD

Micro Road Pilot speed camera warning system - SOLD

Dave

can i have the wing mirrors please

Antnicuk wrote:can i have the wing mirrors please

Sorry Tony, they've already gone.
I've updated the list...

Dave

A pair of Sabelt 4-point harnesses - SOLD

Wheel spacers - SOLD

Set of 4 wheels and tyres - SOLD

Vauxhall X20XEV 'Ecotec' engine - modified to produce ~200bhp - SOLD

Dave

Rear lights.
A pair of Hella stop-tail/indicator units - one of them has some damage to the indicator lens, otherwise in good working condition - some residue where they were bonded into the bodywork. Also rear fog light (originally from a Peugeot 206) - has had one of the original end clips removed, and has some bonding residue, but otherwise good working condition - SOLD.

Momo gear knob and leather gaiter. Knob is in good unmarked condition, gaiter in good condition, could use a bit of clean up - SOLD.

Anyone want a fuel tank? SOLD

Tacho (speedo sold already) - made by ETB Instruments, and was running off the ECU signal on my car, not sure how you change this, but ETB provide great end-user support so may be able to help - good condition - SOLD.

300mm/12" Spal rad fan (pull type) - good working condition, but has been subject to some overspray - SOLD.

Various braided fuel hoses - 2x 5/16" 75mm, 2x 5/16" 35mm, 1x 1/4" 35mm, 1x 1/4" 25mm, 6x proper finishing grommets, 12x hose clips - £10.

Carpets - I pulled the remaining carpets out of the car yesterday. If they are of any use to anyone, you are welcome to them.
Does not include tunnel and floor carpets (they were already absent), just the ones down the sides and the rear bulkhead.
They are not in great condition, but may be usable, or would make good templates for cutting your own.

Rollbar - the car will be away to have a cage made soon(ish), so once that is done, I'll have the rollbar up for grabs too if anyone is looking for one?

Dave

Hi Dave

I would like the carpets to use as templates where about are you as your profile shows Cambridge-ish, we have an engineer pretty close to there who could arrange to collect them for me.

Cheers George

DH2 wrote:Rollbar - the car will be away to have a cage made soon(ish), so once that is done, I'll have the rollbar up for grabs too if anyone is looking for one?

OK, the rollbar is up for grabs now.



Overall height = 500mm.
Overall width = 930mm, width of hoop = 820mm, width between fitting plates on rear braces = 895mm.

Should fit all Stylus chassis without problem. In overall good condition, though some scratches to powder coating.

Open to offers...

Dave

DH2 wrote:OK, the rollbar is up for grabs now.

No one after a roll bar? I could do with it out from under my feet...

Dave

Adjustable panhard rod. Polybushed, though one of the bushes may benefit from replacement.



Also still falling over the roll bar, if anyone needs one?

Dave