congrat's
Posted: Mon May 18, 2009 8:43 am
Kelvin had a good race in his 270bhp Phoenix yesterday , on the Sepang circuit and got 3rd on the podium 
Apparently though , he had a little problem with the ARB 
The nearside poly clamp bolt (one of them ) pulled through the clamp 
At this stage , and not being able to look at it myself , I'm not certain why but have mentioned a few pointers to check.
With this in mind please check that -------
1)The washers under the socket heads have been put in.
2)Graphite grease has been put around the ' bar ' at the clamping points.
3)The socket heads haven't been tightened beyond the poly clamps meeting . Because they're poly -- they WILL deform and force the bolt past the clamping point.
I'll let all know what Kelvin has found once he's had time to dismantle it
Apparently though , he had a little problem with the ARB The nearside poly clamp bolt (one of them ) pulled through the clamp At this stage , and not being able to look at it myself , I'm not certain why but have mentioned a few pointers to check.With this in mind please check that -------
1)The washers under the socket heads have been put in.
2)Graphite grease has been put around the ' bar ' at the clamping points.
3)The socket heads haven't been tightened beyond the poly clamps meeting . Because they're poly -- they WILL deform and force the bolt past the clamping point.
I'll let all know what Kelvin has found once he's had time to dismantle it
but he'd adjusted other things apart from fitting the ARB so it couldn't all be attributed to the ' bar ' . Even so , every little helps 