congrat's

[stylussprinter]

Kelvin had a good race in his 270bhp Phoenix yesterday , on the Sepang circuit and got 3rd on the podium Apparently though , he had a little problem with the ARB The nearside poly clamp bolt (one of them ) pulled through the clamp At this stage , and not being able to look at it myself , I'm not certain why but have mentioned a few pointers to check.
With this in mind please check that -------
1)The washers under the socket heads have been put in.
2)Graphite grease has been put around the ' bar ' at the clamping points.
3)The socket heads haven't been tightened beyond the poly clamps meeting . Because they're poly -- they WILL deform and force the bolt past the clamping point.

I'll let all know what Kelvin has found once he's had time to dismantle it

[stylussprinter]

Told me today that his lap times were quicker by 1.5 sec's but he'd adjusted other things apart from fitting the ARB so it couldn't all be attributed to the ' bar ' . Even so , every little helps

Maybe he'll comment here at some point on his last race