Tim's Bias Bar

Pete&Matt · Post by **Pete&Matt** » Fri Jun 16, 2017 11:26 am

Does anyone have any clue as to what thread Tim used on his own brake bias bar? Usual sizes are 3/8 or 7/16 UNF, of which it is neither!

stylussprinter · Post by **stylussprinter** » Fri Jun 16, 2017 9:03 pm

Blimey , it's so long ago I fitted it , not sure but will try to find out after the weekend - busy with the Alfa at present.

Post by **hearbear** » Sat Jun 17, 2017 1:11 am

I know mine is a 3/8unf, there were no nuts on it and I had to look for some to fit it.

stylussprinter · Post by **stylussprinter** » Sat Jun 17, 2017 7:16 am

Had a quick look at mine with torch then remembered not using nuts at all , I'd pushed a 15mm long piece of rubber fuel inj hose over the ' right side ' end . Marked it with white tippex so I can see if it moved a tad , just glancing down the footwell . Easy to adjust by turning the hose , counting turns looking at the tipex line

Hence - never did know what thread it was

Pete&Matt · Post by **Pete&Matt** » Mon Jun 19, 2017 12:10 pm

it is 3/8 UNF. My supplier sent me 5/16 UNF nuts by mistake! Planks!

Would love to put a piece of hose etc over the end, but IVA wont allow it unfortunately!

stylussprinter · Post by **stylussprinter** » Mon Jun 19, 2017 1:39 pm

Put the ''required'' nuts on for IVA then off once done and use my hose method

Pete&Matt · Post by **Pete&Matt** » Mon Jun 19, 2017 2:21 pm

may well do. To be honest, I fiddled around with the bar when testing the brakes and found no difference in doing so! On a track it most likely shows I would expect

clubstylus

Tim's Bias Bar

Tim's Bias Bar

Re: Tim's Bias Bar

Re: Tim's Bias Bar

Re: Tim's Bias Bar

Re: Tim's Bias Bar

Re: Tim's Bias Bar

Re: Tim's Bias Bar