Follow this route Matthearbear wrote:Matt I'm sure will be along soon I'm sure he had a drawing for the pin to go in the stub instead of the ball joint and then convert to rod end.
Edit check this post out may have all you need
viewtopic.php?f=15&t=1369&hilit=Rod+end
Bottom Balljoint
- MattD
- Stylus owner
- Posts: 693
- Joined: Wed Mar 01, 2006 11:48 am
- Are you a Stylus owner?: yes
- Location: Liphook, Hampshire, UK
Re: Bottom Balljoint
SSC Stylus Integrale Turbo16V
Kit 1999, OTR 2002, and still tweaking....
Kit 1999, OTR 2002, and still tweaking....
- MattD
- Stylus owner
- Posts: 693
- Joined: Wed Mar 01, 2006 11:48 am
- Are you a Stylus owner?: yes
- Location: Liphook, Hampshire, UK
Re: Bottom Balljoint
And here's my original thread on it.... viewtopic.php?f=15&t=618, though my wishbones were made for the job by Rob and aren't Sherpa thread compatible.
Alex's solution above fits the standard wishbone as a Sherpa replacement.
Alex's solution above fits the standard wishbone as a Sherpa replacement.
SSC Stylus Integrale Turbo16V
Kit 1999, OTR 2002, and still tweaking....
Kit 1999, OTR 2002, and still tweaking....
Re: Bottom Balljoint
Thanks, will get the bits on order then soon and get it converted.
Re: Bottom Balljoint
struggling to find the tapper pins!
- MattD
- Stylus owner
- Posts: 693
- Joined: Wed Mar 01, 2006 11:48 am
- Are you a Stylus owner?: yes
- Location: Liphook, Hampshire, UK
Re: Bottom Balljoint
Message the seller directly... he's still using them in all his hot rod kits....Pete&Matt wrote:struggling to find the tapper pins!
http://www.ebay.com/itm/ford-cortina-Mk ... SwGotWqyI2
And don't forget you'll need rubber boots fitted to the rod-ends for IVA inspector (grit ingress, etc) - McGill sell them too.
SSC Stylus Integrale Turbo16V
Kit 1999, OTR 2002, and still tweaking....
Kit 1999, OTR 2002, and still tweaking....
Re: Bottom Balljoint
all ordered now! Will do some photos once they are all fitted up etc!
Thanks
Matt
Thanks
Matt